How to install network card driver in centos

If it's not installed, run "yum -y install system-config-network". Next, run system-config-network in either text or GUI mode and move the configuration that was previously on eth0 over to your new eth2. Next, run "service network restart". Finally, run Reviews: 3.  · yum install kernel-PAE-devel. 3. Download latest driver. ex. wget www.doorway.ru?agr=YDwnldID=ProdId=lang=eng. 4. Untar/unzip archive: tar zxf www.doorway.ru 5. Go to the driver src directory. cd ee-x.x.x/src/ 6. Compile the driver module: # make install. The binary will be installed as:Estimated Reading Time: 30 secs.  · Go to the driver src directory. cd ee-x.x.x/src/ Compile the driver module: # make install. The binary will be installed as: /lib/modules//kernel/drivers/net/ee/ee.[k]o ex. /lib/modules/el5PAE/kernel/drivers/net/ee/www.doorway.ru Load the module using either the Estimated Reading Time: 1 min.

For example, if you use a DVD to install to a local hard drive, the installation will succeed even if drivers for your network card are not available. In such a situation, complete the installation and add support for the new hardware afterward - see Red Hat Enterprise Linux 7 System Administrator’s Guide for details of adding this support. Go to the driver src directory. cd ee-x.x.x/src/ Compile the driver module: # make install. The binary will be installed as: /lib/modules//kernel/drivers/net/ee/ee.[k]o ex. /lib/modules/el5PAE/kernel/drivers/net/ee/www.doorway.ru Load the module using either the insmod or modprobe command: a. i was able to install the centos operating system successfully with my computer but it doesnt have an network card installed on it, ive checked those network card that are supported with centos, but sad to say the driver of my network card is not in the lists, the driver of my card is in a floppy disk, the problem is i dont know how to load it.

How can I install the driver and activate the wired network adapter? Please help. Thanks in advance! Reply. Sunil says: March. Reboot and CentOS will re-acquire network adapters attached to the system. Setup the new NIC via the network configuration wizard: system-config-network. Windows* XP. After you put the adapter in the computer and connect the cable, start Windows XP. Windows XP automatically assigns a driver to.